E30 MtechII S14 turbo. 430HP / 520NM @ 0.8 bar

NickE30M50 · Post by **NickE30M50** » 15 Jan 2010, 18:13

Me like! Damn nice car!

Tim Maatman · Post by **Tim Maatman** » 16 Jan 2010, 00:40

Konny wrote:De var på tiden att du skaffade en pojekt tråd!
Dock har jag ju fått sett alla fina bilder förut när du har skickat dom på msn men den är så fin att man kan se lite till på dom.
Grymt fin bil!! Lycka till i fortsättningen

yes finaly i make a topic , now i have some stuff to show hehe

next things to order is turbo and 2 044 pumps

Tim Maatman · Post by **Tim Maatman** » 16 Jan 2010, 00:41

NickE30M50 wrote:Me like! Damn nice car!

thanks

Tim Maatman · Post by **Tim Maatman** » 17 Jan 2010, 02:08

some pics from today do not much today

Resgard · Post by **Resgard** » 17 Jan 2010, 16:14

Keep up the good work now!

Tim Maatman · Post by **Tim Maatman** » 18 Jan 2010, 22:28

Resgard wrote:Keep up the good work now!

thanks

Tim Maatman · Post by **Tim Maatman** » 06 Feb 2010, 18:05

Oke this week i have some time to do a little on the car ,
i have weld the bracket for the fuel cell together whit the mounting bars for the fuelcell

tomorrow i weld the bracket in the car.

jeenz · Post by **jeenz** » 07 Feb 2010, 23:24

daaamn ! = ))

Tim Maatman · Post by **Tim Maatman** » 08 Feb 2010, 23:40

look this movie from a S14 engine from Van Kronenburg 850pk / 900nm

realy nice

http://www.youtube.com/watch?v=PlaQzn8wV4w

Tim Maatman · Post by **Tim Maatman** » 11 Feb 2010, 22:44

The bracket for the fuelcell is done , also little bit polisching

and make some connection to ground on the fill mouth

Turboá · Post by **Turboá** » 12 Feb 2010, 09:16

precise work

Tim Maatman · Post by **Tim Maatman** » 14 Feb 2010, 13:07

polished al the bracket and bolt it in the car

and the fuel line are arived for 3 cars

AN6 and AN8

thats me haha

Tim Maatman · Post by **Tim Maatman** » 19 Feb 2010, 21:55

Today I cut my cardan shaft and welded it on the M5 hub
I just need to have the cardan shaft balancing

Tim Maatman · Post by **Tim Maatman** » 21 Feb 2010, 21:30

I'am also busy whit a topmount manifold for a honda B18

here some pics

r.ivars · Post by **r.ivars** » 21 Feb 2010, 21:38

nice!

Tim Maatman · Post by **Tim Maatman** » 23 Feb 2010, 20:51

So it is done

only cleaning

btw it is 321 inox 48.3x2.6mm

Tim Maatman · Post by **Tim Maatman** » 23 Feb 2010, 23:21

oke ready