PPF Turbo forum

Hello

Sorry I do not speak Swedish. Most likly someone has posted how to fit dual intake cams on M50 on here, but once again I do not speak Swedish.. Could somebody give me some pointers on how to do this. What kind of modifications are required and how to set it up. People are mentioning some lift measurement on cly 6 I believe.

Thanks

Best regards

you have to use a 4 chuck lathe to take off approximately 3mm where the camsprocket is fastened, so the camsprocket will allign, you will see this once you try to fit the cam.
I use to set up the cam so it lifts 2mm att tdc