questions about turbocharcher for s38b36

e30-turbo · Post by **e30-turbo** » 09 Apr 2007, 00:08

hello, i cant speak swedish, therefore iam writing in english.

i have questions about the fitting turbocharcher for my s38b36 engine.

i will drive with an maximum power from round about 800 hp.

cause my actual charcher is too small.

now iam looking for an new one.. problem is.. my manifold is for T3 flange.

now i cold sell an Turbonetics T70 charcher:

# SHAFT & WHEEL TRIM 64.5mm
# COMPRESSOR WHEEL SUPER 70 60.5mm
# TURBINE HOUSING A/R .84
# COMPRESSOR HOUSING A/R RATIO .70

the seller tell, that i could drive with them round about 800hp...

is that right?

xelerator · Post by **xelerator** » 10 Apr 2007, 21:53

i dont think u can get 800hk with that turbo..

get a bigger one.. with larger compressordiameter, larger A/R on both compressor and turbine side..
dont know the turbine ecducer diameter because you havent givin it, but I think its to small to, so get a larger one there aswell

..

U have a big engine, it could spool most turbos..

change your flange to t4 and you will have many good turbochargers to choose from..