E36 328 M52 indsugnings manifold til tryk? (1,2 bar)

[Since88]

Hej

Where can I find an intake manifold for my E36 M52 328 to run with 1.2 bar pressure. (from a Rotrex compressor). The intake may cost 10.000 kr. max!
I can't find any intake for my car on PPF's webshop. Do they make one? I have looked on this alu intake from Schrick, but i dont know if is good? http://www.schmiedmann.dk/SCINM52/produkt-type/New/find-via-produktnummer.aspx

I don't know if the original 328i "plastic" intake will stick together with 1.2 bar?

Søren

[ToTTeN]

Hej

Where can I find an intake manifold for my E36 M52 328 to run with 1.2 bar pressure. (from a Rotrex compressor). The intake may cost 10.000 kr. max!
I can't find any intake for my car on PPF's webshop. Do they make one? I have looked on this alu intake from Schrick, but i dont know if is good? http://www.schmiedmann.dk/SCINM52/produkt-type/New/find-via-produktnummer.aspx

I don't know if the original 328i "plastic" intake will stick together with 1.2 bar?

Søren

My m50b25 intake has not blown up yet. 2.5years with 0.7 - 1.4bar. Right now 1.1bar and 375whp

[Since88]

Thanks. Good to know.

But does PPF make an intake manifold for my M52 ?

[Bmwandreas]

Yes we do. But i don't know if it will fit with sc.
Run the stock intake, it will hold up just fine.

[Since88]

Thanks for the answer, I will run on the stock then.

I only have an M52 328i intake. Would the M50 2.5 intake bring me more power when it run with sc?

[Pimplaren]

People puts a b25 intake on a b28 engine! there is alot of bimmers with original m50 intake and alot of hps