10tsdkm run, JE pistons, H-shaft rods, 990ccm injectors, MLS headgasket, ARP bolts, Turbonetics T76 ballbeariing Turbo, PPF fuelrail, 600x300mm intercooler, 60mm ppf pop off...all parts in the engine NEW! light crankshaft! inkl completely exhaust! 3,5" and NEW Carbonairbox http://img1.bildupload.com ...

erik@e30 wrote:Yes!! butt you must Modify your "flange"

http://www.pure-pf.com/phpBB2/viewtopic ... &start=152

i can´t speak swedish, so i cant read this link for this theme

what i must modify in my 535i flanges? they fitted only problems in my e30 rearhubs

hello

does fit the PPF driveshafts with my montered parts?


1: E28 535i diff
2: E34 535i flange
3: orig. e30 rear



tanks

iam searching driveshafts for my e30 with e28 m535 diff (210)

FoX wrote:

Micke wrote:Ser ju bra ut det där, men varför ska du köra med custom motorfästen?

Dels för att org motorfäste spricker(med org effekt), dels för att jag inte tror att allt kommer passa med org motorfästen, det återstår och se.

wich driveshafts do you use?

wich driveshafts do you use?

wich driveshafts do you use?

nice colour.. ist this ferrari silverstone grey?

iam looking for an s38 or s50 turboengine in an good condition.

yes. weve grindet head and block new! i drove the last 1300km with just 0,6 bar pressure.. but next week, the engine will dynoed. if i got the last time problems with the wather/exhaust gas, the ARP bolts between 4th and 5th cylinder was loose.. i retoqued it.. cause i needet an half rotation for ...

ok. much thanks! my problem is.. i drove with my engine round about 500km.. after then ive got exhaust gas in the cooling whater circulation. i took an new headgasket.. torqued the ARP bolts with 120NM.. so i drove about 800km.. and ive got again exhaust gas in my whater circulation. so the exhaust ...

i drive an MLS headgesket from PPf.. now i must take of my cylinderhead.. can i use the old mls gasket again, ore do i need than a new one? the headgasket has been run about 800km

iam looking for an good charcher for an s38 engine. maybe an holset hx52 55 ore an garrett GT42 etc.....

do you use an 6 speed gearbox from s38b38?

hello, i cant speak swedish, therefore iam writing in english. i have questions about the fitting turbocharcher for my s38b36 engine. i will drive with an maximum power from round about 800 hp. cause my actual charcher is too small. now iam looking for an new one.. problem is.. my manifold is for T3 ...